Skip to content
electricistaentrevegas.comReport a fault
Menu

We rewire homes, business premises and villas

We replace installations from the 70s, 80s and 90s with a safe installation that has the circuits a modern home needs, and we do the electrical work for renovations, new builds, air conditioning and pools.

Chases and new conduit for rewiring an old flat

Installations and rewiring

Rewiring: what it involves

An installation from forty or fifty years ago was designed for a few light bulbs, the fridge, the washing machine and little else. Today the same house has air conditioning in every room, an induction hob, an oven, a water heater, a tumble dryer and chargers everywhere. The cables are usually the original ones, sometimes with no earthing, with joints added over the years and a consumer unit that doesn't protect people.

Rewiring doesn't always mean tearing the whole house apart. We assess what is there and suggest what makes sense: from replacing the consumer unit and pulling new cable through the existing conduits when they are in good condition, to a complete installation with new chases if you are renovating anyway. The result complies with the REBT and is fully documented.

We work in flats in Murcia city and its outlying districts, in bungalows and apartments around the Mar Menor and on the coast of Torrevieja and Orihuela, in country houses and new-build villas, as well as in shops and small businesses.

Cases and jobs

Rewiring and electrical renovations we carry out

The ones we are asked for most, with an explanation, followed by the other jobs in this service.

Rewiring a 1970s flat

Flats in older blocks in Murcia city and its outlying districts with cloth-covered or two-wire cables, no earthing and fuses. We replace all the wiring and separate the circuits required by ITC-BT-25: lighting, sockets, cooker and oven, washing machine and water heater, and bathroom and kitchen. We connect to the building's earthing, fit a new consumer unit and replace the switches and sockets. Wherever the conduits allow, we pull the new cable through them so we open as few chases as possible.

Two-wire installation with no earthing

In many older homes each circuit has only live and neutral, and the earth pins on the sockets are just for show. Without earthing, an appliance with a fault puts voltage on its casing and the leak has nowhere to go until someone touches it. We run the protective conductor to every socket and appliance, connect it to the building's earthing network or to a new earth rod in houses, and measure the earth resistance.

Electrics for a kitchen refit

Kitchens that go from a couple of sockets to an oven, induction hob, dishwasher, microwave, extractor hood and fridge-freezer. We wire each circuit with its proper cable size: 6 mm² for the cooker and oven, 4 mm² for the washing machine, dishwasher and water heater, and the worktop sockets on their own line. We place the sockets at worktop height, leave the supply for the hood and the under-cabinet lights, and coordinate with the kitchen fitter so the openings line up.

Bathroom electrical refit

In the bathroom we respect the zones set out in ITC-BT-27: no socket goes next to the shower or bath, light fittings have the protection rating that matches their zone and the circuit has 30 mA RCD protection. We move the light points to the new ceiling, prepare the supply for the illuminated mirror, the extractor fan and the heated towel rail and, if you like, electric underfloor heating.

Dedicated line for the air conditioning

Split units and ducted systems plugged into a socket circuit that is already loaded are a classic cause of hot sockets and tripping in the middle of August. We run a dedicated line from the consumer unit to each unit or to the outdoor unit, with its own circuit breaker, RCD protection and the cable size the appliance's power requires. We leave the connection point next to the unit so the air conditioning installer only has to connect it.

Electrical installation for a new-build villa

New villas in Corvera, the airport area or the developments in the Murcia countryside: we do the installation from the general protection box to the last light point. Individual supply line, high-electrification consumer unit, climate control circuits, pre-wiring for the car charger, garden and pool lighting, and the paperwork to get the supply connected.

More cases we deal with

  • Cloth or rubber cables that are crumbling

    When you move a switch or socket, the insulation cracks or falls off in pieces. The wiring has reached the end of its life: we replace it entirely with new cable of the right size for each circuit.

  • 1980s bungalow on the coast

    Bungalows and apartments in Orihuela Costa, Torrevieja or the Mar Menor with the original installation, switches and sockets corroded by salt air and a small consumer unit. We renew circuits, consumer unit and fittings and protect everything on the terrace and outdoors.

  • Joining two flats or changing the layout

    When walls come down or two homes are joined, cable routes and loads change. We redesign the circuits, leave a single consumer unit and document the new installation.

  • Swimming pool electrical installation

    Pool pump, lights and heat pump on their own circuit with an RCD. The underwater lights run at 12 V with their safety transformer outside the pool zones, and we bond the metal parts with the equipotential bonding required by ITC-BT-31.

  • Electrical refit of a shop

    Premises being refitted before opening: a consumer unit with circuits by zone, general and shop-window lighting, work sockets, climate control and, where the premises require it, emergency lighting and documentation for the opening licence.

  • Office with many workstations

    Workstations with computers, printers and network equipment on separate circuits, high-immunity RCDs that don't trip because of electronics, and enough sockets so you don't depend on extension leads.

  • Restoring a house in the huerta

    New installation, earth rods, a line to the storeroom or the well and outdoor lighting, all from a consumer unit with the protection for each area.

  • Electric heating or aerothermal heat pump

    Radiators, electric underfloor heating or a heat pump need their own circuit and often more power. We run the lines and adapt the consumer unit.

  • Garden, irrigation and electric gate

    An underground line in conduit to the garden lamp posts, the irrigation timer and the gate motor, with weatherproof boxes and dedicated RCD protection in the consumer unit.

  • Garage or basement in a detached house

    Villa garages with sockets for tools, good lighting, a socket for the freezer and the line ready for the car charger.

Signs that an installation is too old

You don't need to open up the walls to have your suspicions. If the home hasn't been rewired since the 70s, 80s or early 90s, it probably shows several of these signs:

With two or three of them, the sensible thing is to have the whole installation inspected before adding more appliances.

  • A consumer unit with fuses, a single old RCD or no RCD at all.
  • Sockets with no earth or with the earth not connected.
  • Cloth-covered cables or rubber that cracks when bent.
  • Very few circuits: lighting and sockets for half the house on the same line.
  • Sockets or plugs that get hot, scorch marks or loose switches and sockets.
  • Daisy-chained extension leads because almost every room is short of sockets.

Cable colours in an old installation

In a modern installation the colours are standardised: blue is neutral, green and yellow is earth, and brown, black and grey are reserved for the live phases. In old installations this is not always the case: there are neutrals of other colours, earths that don't exist, the same colour for every wire or sections reused in partial renovations.

That is why the colour alone isn't enough to know what each cable is. Before working we test every conductor with measuring instruments, and once rewired everything has the regulation colours and each circuit is labelled in the consumer unit.

Which circuits a home needs under the REBT

ITC-BT-25 sets the minimum circuits for a home. With basic electrification there are five: lighting; general-purpose sockets; cooker and oven; washing machine, dishwasher and water heater; and bathroom and auxiliary kitchen sockets. High electrification adds circuits for heating, air conditioning, a tumble dryer or home automation, extra circuits when there are many light points or sockets, and the electric car charging circuit when one is installed.

Each circuit has its own circuit breaker, rated to match the cable size, and all of them are protected by 30 mA RCDs. That way, a fault in the washing machine doesn't leave the living room in the dark and the consumer unit shows you where the problem is.

What you get

What you get when we do it

  • Less building work

    We reuse existing conduits and routes when they are in good condition and keep chases to where they are really needed.

  • Safety for people

    Earthing on every socket and RCDs on every circuit: what really protects you from an electric shock.

  • Designed around how you live

    Circuits for the air conditioning, the kitchen and the electric car, and sockets where you need them, with no extension leads.

  • Paperwork in order

    The new installation is certified, ready for a power increase or a contract change whenever you need it.

How we work

How we fix it, step by step

  1. Visit and inspection

    We look at the home or premises, open the consumer unit and boxes, take measurements and ask how you use the house.

  2. Written proposal

    We explain what is worth renewing, what can be kept and how the work will be organised.

  3. Installation work

    Chases, conduit, wiring, consumer unit and fittings, coordinated with the builder, carpenter or plumber if there is a renovation.

  4. Testing and certificate

    We measure insulation and earthing, test the RCDs and hand you the documentation for the installation.

Frequently asked questions

Questions about rewiring

How much does it cost to rewire a flat?

It depends on the floor area and number of circuits, whether the existing conduits can be used or chases need to be cut, the consumer unit required, the range of switches and sockets, and whether the rewiring coincides with a renovation that already includes building work. It also matters whether the building has an earthing network and whether you want to raise the power and update the certificate. We send you an itemised quote after seeing the home.

Can the installation be renewed without building work?

Partly, yes. If the embedded conduits are in good condition and wide enough, we pull new cable through them and replace the consumer unit and fittings without cutting chases. Where there is no conduit, the cable is stapled directly or the conduit is crushed, the wall has to be opened. For specific areas there are also trunking and mouldings that avoid touching the wall.

How do I know if my installation has earthing?

Sockets with side earth contacts are not proof, because they may not be connected. We check by measuring at every socket and at the consumer unit. In flats, the building normally has an earthing network to connect to; in houses, if there isn't one, we drive in earth rods and measure until we get a suitable value.

Do I need a certificate after rewiring?

If the rewiring changes what was certified (new circuits, consumer unit, supply line or power), the right thing is to issue a new certificate, which you will also need if you ever raise the power or have to get the supply reconnected. We prepare it when we finish, with the measurements of the new installation.

Can you run just the line for the air conditioning or the pool?

Yes. If the consumer unit has space and the power allows it, we run only the new line with its protection. If the consumer unit is old or full, we replace it at the same time, because it is the part of the installation that protects the people living in the house the most.

You may also be interested in

Related services

Electrical certificate

Electrical installation certificate for new connections, second homes, newly finished villas and shops, with a prior inspection and all the paperwork.

See the service

LED lighting

LED lighting for living rooms, kitchens, gardens, façades, pools, shops and communal areas, with sensors and switching designed for each use.

See the service

Shall we talk it through?

Tell us what you need and where it is: we will reply with what it takes to do it properly.