Skip to content
electricistaentrevegas.comReport a fault
Menu

LED lighting installation indoors, outdoors and in communal areas

We design and install lighting for homes, gardens, pools, façades and businesses with well-chosen LEDs, and fit sensors in garages and stairwells so the lights are only on when needed.

LED garden and pool lighting at a villa at dusk

Installations and rewiring

LED lighting: what it involves

Switching to LED isn't just changing bulbs. Good lighting decides where each light point goes, its colour temperature, how much light it gives, how it is switched on and what protection rating it needs if it is outdoors or near water. Done well, you notice it in comfort, on your bill and in how your home or business looks.

We do all the electrical work: circuits and conduit, recessed boxes for downlights, power supplies for LED strips, compatible dimmers, sensors, timers and dusk-to-dawn switches, and the underground line for the garden or pool. If you need it, we help you choose the light fittings on technical grounds.

We work in homes in Murcia and its outlying districts, in villas with gardens in the countryside and on the coast, in communities of owners and in shops that want to sell better with lighting that shows off their products.

Cases and jobs

Lighting installations we carry out

The ones we are asked for most, with an explanation, followed by the other jobs in this service.

Recessed LED downlights in a false ceiling

Living rooms, kitchens and hallways with a plasterboard false ceiling where we replace a single ceiling light with several well-spaced points. We plan the layout so the light is even, choose the colour temperature (warm in living areas, neutral in the kitchen and bathroom), split the switching by zone and leave the power supplies reachable through the openings. If you want to dim the lights, we fit fittings and a dimmer that are compatible with each other.

Garden and path lighting

Bollards along the paths, uplighters on an olive tree or a palm, wall lights on the fence and lighting in the barbecue area. We lay the underground line in conduit to each point, use weatherproof junction boxes and fittings rated for outdoor use, and connect it to a circuit with its own RCD in the consumer unit. It can be switched on by a switch, by a dusk sensor that turns it on at nightfall or by an astronomical timer.

LED pool lights

We replace old halogen pool lights with LEDs or install new lights in the pool shell. Underwater lights run on safety extra-low voltage, 12 V, powered by a safety transformer placed away from the water, where the regulations allow. We check the circuit, the junction box and the equipotential bonding, and light the surroundings with fittings suitable for wet areas.

Presence sensors in garages and stairwells

Community stairwells and garages with the lights on for hours, or with timers that leave you in the dark halfway along. We replace the fluorescent tubes with LED fittings and fit sensors by section, so the area you walk through lights up and switches off when nobody is there. The emergency lighting stays separate and works on its own if the power goes off.

LED lighting for a shop

Shops, greengrocers, hair salons or cafés where lighting also sells. We combine general lighting with tracks and adjustable spotlights for products and the shop window, with a high colour rendering index so colours look natural, and split the switching for opening, closing and cleaning. If the premises need it, we also check the emergency lighting and its signage.

More cases we deal with

  • Façade lighting for a villa or shop

    Wall washers, up-and-down wall lights and spotlights to highlight the entrance or the sign. We choose weatherproof fittings and aim them so they don't dazzle the neighbours.

  • LED strips in kitchens, ceilings and furniture

    Lighting under the kitchen wall units, in ceiling coves or in display cabinets, with an aluminium profile, diffuser and a correctly sized, accessible 12 or 24 V power supply.

  • LEDs that keep glowing slightly when switched off

    That faint glow is caused by switches with an indicator light, cables inducing voltage or a switch that breaks the neutral instead of the live. We find the cause and correct it in the switch or the wiring.

  • LED lights flickering with the dimmer

    Old dimmers designed for halogens with LED lamps that aren't compatible. We fit a compatible dimmer or replace the lamps with dimmable ones.

  • Replacing fluorescent tubes with LED panels

    In garages, storerooms, workshops and offices we replace fluorescent fittings with LED, removing ballasts and starters or replacing the whole fitting.

  • Terrace lighting for coastal apartments

    Weatherproof wall and ceiling lights that stand up to salt air and damp, with protected outdoor switches, on terraces in La Manga, Torrevieja or Orihuela Costa.

  • LED high bays in industrial units and warehouses

    Units with discharge lamps that take a while to reach full brightness. We fit LED high bays at the right height and split the switching by work area.

  • Emergency lighting in a community or shop

    Self-contained units that come on when the power fails along exit routes, stairwells and garages. We replace those with dead batteries and check they work by cutting the supply.

  • Switching lights from two or three points

    Hallways, internal staircases and bedrooms with two-way and intermediate switching to turn the light on at one end and off at the other.

  • Automatic lighting at the entrance and parking area

    Spotlights with motion sensors at the door, the parking area and the sides of the villa, with sensitivity and timing adjusted so they don't come on for every passing cat.

  • Dimming and lighting scenes in the living room

    Several dimmable lighting circuits for reading, watching a film or having dinner. We install dimmers and, if you prefer, smart switches to control the lighting from your phone.

How to choose the right LED lighting

Three figures explain almost everything. Lumens tell you how much light the lamp gives; watts only tell you how much it uses. Colour temperature, in kelvin, shows whether the light is warm (around 2,700 to 3,000 K), neutral (about 4,000 K) or cool (5,000 K and above). And the colour rendering index (CRI) tells you how faithfully colours are shown: above 80 for the home and above 90 in shops where the colour of the product matters.

Outdoors, the IP protection rating also counts: the first number indicates protection against dust and the second against water. For exposed outdoor locations we use IP65 or higher fittings, and IP68 for anything submerged.

Garages and stairwells: sensors and emergency lighting

In communal areas, most of the lighting consumption is time spent on with nobody there. Presence sensors by section and LED fittings greatly reduce that time if they are well placed: in a garage, a badly aimed sensor leaves whoever gets out of the car in the dark.

Emergency lighting is something else: battery units that come on if the supply fails to light the exit routes. The Spanish Building Code (Código Técnico de la Edificación) requires it, among other places, along evacuation routes and in enclosed car parks above a certain size, and premises open to the public also have their own requirements under the REBT. When we renew the lighting, we check that the emergency units work and that their batteries hold up.

What you get

What you get when we do it

  • Light where it's used

    Well-spaced points and switching by zone: no more lonely ceiling light and corners in shadow.

  • Lower consumption

    Efficient LEDs and sensors in through areas: the lights are on when someone needs them.

  • Suitable for outdoors and water

    Protection ratings, weatherproof boxes and extra-low voltage where needed: garden and pool without risks.

  • Switching that makes sense

    Switches, two-way switching, dusk sensors or astronomical timers, each where it is most convenient.

How we work

How we fix it, step by step

  1. Tell us about the space

    Through the form or by email: what you want to light, approximate measurements and a few photos if you can.

  2. Lighting proposal

    We propose light points, type of fitting, colour temperature and switching, with the routes for the lines.

  3. Installation

    We run the lines, fit boxes, power supplies, dimmers and sensors, and install the light fittings.

  4. Final adjustment

    We aim the spotlights, adjust sensors and dusk switches and test each switch with you.

Frequently asked questions

Questions about lED lighting

How much does LED lighting cost at home or in the garden?

It depends on the number of light points, whether there is already a false ceiling or one needs building, whether the line is recessed, surface-mounted or underground, the type of fittings and whether you want dimming, sensors or automatic switching. For pools, it also depends on whether the lights are replaced or new ones are installed. After seeing the space we send you a proposal with a quote.

Can I use LED bulbs with my existing dimmer?

Only if the dimmer and the lamps are compatible. Many old dimmers were designed for halogens and, with LEDs, cause flickering, buzzing or don't dim properly. We check the model and, if needed, replace it with one suitable for LEDs and use dimmable lamps.

Which colour temperature should I use in each room?

Warm light in the living room and bedrooms; neutral in the kitchen, bathroom and work areas; cool we keep for garages, workshops or storerooms. The important thing is not to mix different temperatures in the same room, because it is very noticeable and the light looks lower quality.

What lights can be fitted in the garden and the pool?

In the garden, outdoor fittings rated IP65 or higher, cable suitable for burying in conduit and a circuit with its own RCD. In the pool, the lights in the pool shell run on safety extra-low voltage and are rated IP68, and around it fittings for wet areas are used at the distance set by the regulations.

Can a sensor be fitted in the garage without leaving anyone in the dark?

Yes, by placing the sensors by section with their range properly planned, so the light comes on before you reach each area and not just next to the door. The emergency lighting remains independent and comes on if there is a power cut.

Is it worth replacing the garage fluorescent tubes with LED?

In garages and storerooms where the lights are on for many hours, yes: LED uses considerably less, comes on instantly without flickering and needs no starters or ballasts. Combined with sensors, the difference on the community's bill is noticeable.

You may also be interested in

Related services

Rewiring

Old installations with no earthing or two-wire circuits, kitchen and bathroom refits, shops, new-build villas, air conditioning lines and swimming pools.

See the service

Communities of owners

Stairwells, garages, pumps, pressure booster sets, emergency lighting and door entry systems: we repair faults in your building's communal services.

See the service

Shall we talk it through?

Tell us what you need and where it is: we will reply with what it takes to do it properly.