Skip to content
electricistaentrevegas.comReport a fault
Menu

Emergency electrician for businesses: cold rooms, servers and machinery

When a business loses power, every piece of equipment that stops costs money: the stock in the cold room, the orders on the server, production or the till. We get the essentials running first, safely, and then repair the fault and leave the installation better prepared.

Emergency electrician for businesses checking the panel of a cold room full of stock

No power or equipment down

Business emergencies: what it involves

In a business, the emergency is also about stock and customers. A butcher's with the cold room stopped, a restaurant without extraction, an office with the server down or a warehouse with production at a standstill needs to get back first whatever is stopping it from working. On arrival we identify the critical circuits and put them back into service as soon as we've checked they're sound.

Then we find the cause: the defrost heater tripping the RCD, a lost phase that has stopped the compressors, a burnt terminal, a UPS with no batteries or a generator that doesn't take over because the changeover has failed. We repair it and explain what happened so you can decide on improvements with full knowledge.

We serve shops, hospitality businesses, food production workshops (obradores), offices, clinics, workshops, fruit and vegetable warehouses and industrial units in and around Murcia, the Mar Menor and the coast around Torrevieja and Orihuela Costa.

Cases and jobs

Business equipment we get running again

The ones we are asked for most, with an explanation, followed by the other jobs in this service.

Cold room stopped with stock inside

In butchers, fishmongers, supermarkets, ice cream parlours, restaurants and fruit warehouses, the cold room comes first. We check its panel, the compressor's motor protection breaker and contactor, all three phases, the controller and the defrost heater, which is the most frequent cause of the RCD tripping. We get the refrigeration running as soon as the electrics allow and put the cold room on its own circuit.

Server or rack without power

In offices, administrative agencies (gestorías), clinics and warehouses with their own server, an outage leaves the business without its data. We check the rack circuit, the UPS and its bypass, the socket and the protective device, and restore power safely. If the UPS went down with exhausted or swollen batteries, we switch it to bypass, replace the batteries and separate the IT equipment from other loads.

Production machinery stopped in an industrial unit

In workshops, carpentry shops, printers, bakeries or packing plants, one machine stopping halts the line. We check the power supply, phases, motor protection breakers, contactors, thermal relays and limit switches, and determine whether the fault is in the building or in the machine's control circuit. We repair it and start the machine, checking its current draw.

Generator that won't start or take over

If the generator doesn't start, or starts but the panel doesn't switch over to it, the changeover is failing: the automatic transfer panel, its contactors, mains detection, the starter battery or the controls. We repair it and test it by simulating an outage. If you don't have a generator and need one, we fit a connection point and changeover switch for a hired unit with no risk of feeding power back into the grid.

Restaurant without extraction or kitchen

Without the extractor hood there's no cooking, and without fryers, griddles or dishwashers there's no service. We check the kitchen panel, the equipment's three-phase lines, the extractor motor and its speed controller, and sockets burnt by grease and heat. We leave the kitchen working and separate the equipment that was drawing from the same protective device.

More cases we deal with

  • UPS that beeps, shuts off or won't hold

    We check the batteries, load and power supply, replace the batteries and remove whatever is overloading it so it protects what can't be switched off.

  • Till, card terminal and alarm off at opening time

    We restore those circuits first so you can open, and then locate the general fault in the premises.

  • Shop's metal shutter that won't go up

    We check the motor, the electric brake, the push button or key switch and the power supply, and leave it going up and down.

  • Bar with bottle coolers, ice machine and air conditioning all stopped

    We find the protective device or phase they share, repair it and spread the load across several circuits.

  • Commercial coffee machine or dishwasher tripping the panel

    We check the heating elements, socket and line, and give them a circuit suited to their power.

  • Pharmacy or clinic with the medicine fridge stopped

    We restore its circuit, check the protection and separate it from the rest of the premises.

  • Dental clinic with the chair or compressor stopped

    The chair, compressor, suction unit and autoclave run on their own lines. We find the one that has failed and get it back in service.

  • Car repair workshop with the vehicle lift or compressor stopped

    They're three-phase and sensitive to lost phases and tripped motor protection breakers. We check the power supply and controls and get them running.

  • Supermarket with chiller cabinets and chest freezers stopped

    We restore commercial refrigeration and split it into groups so one fault doesn't shut down the whole section.

  • Fruit and vegetable warehouse with cold rooms and grading machine stopped

    When the main incoming protection trips or a phase is lost, everything stops. We locate the fault and restore refrigeration first.

  • Farm irrigation head unit stopped

    We check the pump panel, controller, solenoid valves and power supply, and get it irrigating before the crop suffers.

What to do in your business while we're on our way

A few simple steps protect your stock without putting anyone at risk. Tell us in the form which equipment is critical and where the main panel is.

  • Don't open the cold room or chest freezers more than absolutely necessary: the cold lasts longer with the door shut.
  • Switch off sensitive equipment so it doesn't all start at once when the power comes back.
  • If a protective device trips, push it up just once; if it trips again, leave it down.
  • Don't touch panels with water nearby or machines that smell of burning.
  • Don't connect a generator to the panel with extension leads or jumpers: it can feed power back into the grid and electrocute someone working on it.

Critical equipment: how to stop the next fault shutting you down

Serious stoppages keep happening for the same reasons: a single RCD for the whole premises, refrigeration sharing a circuit with the kitchen, motors without phase monitoring and UPS units nobody checks. We suggest what fits your activity:

  • Dedicated circuits for cold rooms, servers and machinery.
  • RCDs with automatic reclosing for refrigeration.
  • Phase monitoring relays on compressors and pumps.
  • A connection point and changeover switch for a generator.
  • UPS battery checks and generator testing with a simulated outage.

Seasonal businesses on the coast

On the Mar Menor, in Torrevieja and Orihuela Costa, many bars, ice cream parlours and holiday accommodation businesses are at their busiest in summer after months closed. Winter damp and salt air take their toll on panels, cold rooms and shutters just when there are most customers; checking them before the season avoids most of the July and August emergencies.

What you get

What you get when we do it

  • Critical systems first

    Refrigeration, servers, till or production before the full repair.

  • We understand control systems

    Motor protection breakers, contactors, changeovers and phase monitoring.

  • No dangerous bodges

    No jumpers or extension leads: everything is protected as the REBT requires.

  • A plan so it doesn't happen again

    In writing: what failed and what to change so it doesn't stop you again.

How we work

How we fix it, step by step

  1. Tell us what has stopped

    Type of business, critical equipment and what you see in the panel, via the form or by email.

  2. We isolate and restart

    We separate the faulty part and power the essentials.

  3. We repair the cause

    Protective device, terminal, phase, UPS or changeover.

  4. We test under real load

    We start the equipment and simulate an outage if there's a generator or UPS.

Frequently asked questions

Questions about business emergencies

The cold room in my business has stopped. What should I do?

Keep the door closed, check whether any protective device has tripped and push it up just once. If it trips again or nothing is down, tell us which cold room it is. We check its electrical side and, if the fault is in the refrigeration system itself, we tell you so you can call your refrigeration technician.

Can you connect a generator to my premises?

Yes, always through a changeover switch that separates the grid and the generator, so the generator never feeds power back into the street. We fit the connection point and changeover switch for a hired generator, or an automatic changeover if you need it often.

The server's UPS is beeping and won't hold. What's wrong with it?

It's almost always exhausted batteries or a UPS with more equipment than it can support. We check it, replace the batteries and leave connected only what it should protect.

Why does one machine stop while the rest of the unit keeps running?

Often because of a lost phase: lights and sockets on the other phases keep working, but three-phase motors stop. It can also be a tripped motor protection breaker or thermal relay, or the machine's own controls.

Can you work without closing the premises?

Whenever possible. We isolate only the circuit we're working on and the rest keeps running; if the main switch has to be turned off, we choose the least disruptive time with you.

What information should I give you when I get in touch?

Type of business and address, which equipment has stopped, what you see in the panel, whether it's single-phase or three-phase and whether you have a UPS or generator. With that we come with the most likely materials.

You may also be interested in

Related services

RCD keeps tripping

RCD or breaker tripping with the oven, water heater, air conditioning or for no obvious reason: we test the insulation and eliminate the leak.

See the service

Is it happening right now?

Tell us what is happening, where it is and a phone number. In the meantime, if there is a burning smell, sparks or water, switch off the main switch only if you can do it safely.